Certifications & Compliance
Our EV charging products are type-tested and certified by TÜV Rheinland and other accredited bodies. The register below covers the in-cable control and protection device (IC-CPD) and Mode 3 EVSE wallbox product families, spanning EU CE (LVD / RED), UKCA, the IEC CB scheme, RoHS and the New Zealand RCM.
European Union — CE
2 certificatesCE marking for the European Economic Area: the low voltage directive (LVD) covers the in-cable control and protection device, and the radio equipment directive (RED) covers the Mode 3 wallbox, which carries wireless communication.
CE — Low Voltage Directive (EU) 2014/35
CE — Radio Equipment Directive (EU) 2014/53
United Kingdom — UKCA
2 certificatesUKCA is required for placing the same product families on the Great Britain market after the end of the CE transition. Both the wallbox and the IC-CPD are covered.
UKCA — Radio Equipment Regulations 2017
UKCA — Electrical Equipment (Safety) Regulations 2016
IEC CB scheme
2 certificatesCB test certificates issued under the IECEE scheme. They are the basis for national approvals in participating countries and shorten the lead time when entering a new market.
IEC CB Test Certificate — EVSE
IEC CB Test Certificate — IC-CPD
TÜV Rheinland — type approval & test report
2 certificatesIndependent type approval against EN 62752 plus the full test report covering the EVSE safety, EMC and radio series. The report is the evidence behind the marking.
TÜV Rheinland Type Approved — EN 62752:2016+A1
TÜV Rheinland Test Report — EVSE (Pass)
Material & market access — RoHS, RCM
2 certificatesRestricted substance verification for the EU market, and the supplier’s declaration of conformity that supports the RCM mark for Australia and New Zealand.
RoHS — Verification of Conformity
